FW Arms™ now makes a 7/8-14 flange nut to distribute the downward force generated when tightening your dies. This allows to achieve the same holding force as a standard nut but with less torque. The FW Arms™ nuts are made from 1.25″ dia steel and then the 1″ hex is milled on each part. We’ve cut relief on the backside of the flange so only the outer ring makes contact with the clamping surface, this ensure that weight is distributed along the OD vs the ID which helps keep your dies aligned. We have made them 7/32″ thick. Plated black to prevent rust as well as a great look on any press.
We make these inhouse in Las Vegas, NV.
!!! DO NOT USE FOR STRUCTURAL PURPOSES !!!
Sold in packs of 5