DESIGNED AND MANUFACTURED IN LAS VEGAS, NV USA
If you’re using an automated Super 1050 to process rifle brass you know what a pain the swage station can be. Nipped necks, crushed cases, not to mention the slow speeds you need to run. From the casual reloader to the large processor, the FW Arms™ Hold Down is the perfect addition to your die lineup. Using the same patented design the FW Arms™ Auto-Center Decapper, ensure your hold down goes inside the case every time. Since the FW Arms™ Hold Down centers your case neck, damage to your case from misalignment is almost down to zero. This means less down time, less scrap, and higher efficiency.
Mark 7® Evolution/Revolution USERS
Guess what! You can use your F.W. Arms™ Hold Down in the primer station. Tighten up your primer seat depth deviation by eliminating shell plate flex.
SUPER 1050 USERS
At the moment the FW Arms™ Auto-Center design is compatible with cases up to 2.25″ in length that have a neck I.D. no less than .22 This was decided based on which cases are most likely processed in large batches such as .223 Rem, or .308 Win.
Are you currently using swage kits that come with a backer rod and require you to guide the case up into the die? No more, swap your existing swager backer rod die out for the FW Arms™ Hold Down and see how much easier it is to swage in in a single stage press.
Each die comes with our Premium Nut. Turned from solid steel hex stock, these nuts are still 1″ across the flats and measure .305″ thick. If you want some F.W. Arms nuts click here!
Make setting up your swage station as easy as possible with the AmmoBrass Swage Setter
We don’t stock them, but we like them…a lot. Click on the link to open a new tab to AmmoBrass and check them out! AMMOBRASS SWAGE SETTERS
!!! FREE SHIPPING ON ORDERS OVER $75 !!!
U.S. Patent 10,794,676 and 11,021,111, and other patents pending.