Description
Why choose F.W. Arms™ shell plates
You want an F.W. Arms™ shell plate for the same reason you want(ed) our decapper, it helps lower the potential for problems. We have found that the #1 issue for decapper pin failure is a jumped case that ends up positioning the case head right under the pin. Cases jump for a number of reasons but the problem always gets worse at the high speeds that auto-drives since the case is moving faster and it becomes a bit more difficult to locate the case flange into the plate. Each case station has had the geometry optimized for high speed case feeding but also to allow minimal wiggle of the case once it’s in place. Keep in mind we need to cut the pockets to just over saami spec to cover all cases. Cases on the small end of the saami tolerance will wiggle more.
Plates are laser engraved with the shell plate number. We’ve also added numbers to each of the case stations because I’ve always felt that the case stations needed numbers to help keep track of.
We’ve also machined these plates to work with a stock Dillon indexing pawl.
This plate comes with our #3 station tabs
On the backside we’ve added geometry that is first of it’s kind:
- Dedicated track for the indexing ball to ride in, this helps the plate stay on center while going around the press.
- Machined arcs along the backside to to encourage debris removal during operation.
F.W. ARMS™ is offering our new shell plates to fit the Dillon 1050/1100/CP2000 presses.
Includes the F.W. Arms™ index pawl (not required to use plate)
Use the F.W. Arms™ letter W shell plate for 40SW, 357 Sig, 10mm, 9×25 Dillon,
Tool steel design with Cerakote coating, heat treated for optimal endurance
Enhanced geometry to allow smooth case feeding
!!! FREE SHIPPING ON ORDERS OVER $125 !!!
Reviews
There are no reviews yet.